Hi Everyone,

The technician has been in and serviced the F170 Stratasys printer in 5180. We've run a test print and think we know the issue that caused the problem - the head change and excessive vibration taking the unit out of calibration. The unit was serviced, power cycled, disconnected from power and then when powered up a manual calibration was run. After adjusting the for the manual calibration (it showed it was out of the required tolerances) an automatic calibration was run and another manual calibration to confirm the results of the automatic one (the manual calibration showed it was aligned within tolerances). It's been printing for a couple of hours without issue.

Thanks, -John