Hardware May 2022

hardware@dgp.toronto.edu

1 participants
3 discussions

Training for hardware room access Friday May 20th, 1 pm
by John Hancock 18 May '22

18 May '22

Hi Everyone, I'm going to be running a training Friday at 1 pm for the hardware room (BA5180) and then if the space is available the seminar room video system. If you can't make Friday at 1 pm, there will be some additional training the following week. Thanks, -John

1 0

Training for the hardware room access
by John Hancock 11 May '22

11 May '22

Hi Everyone, We're restarting training for the hardware space. If you are interested in getting an update or having your door access re-instated, I'm going to run some sessions this week and over the next few weeks to train on the equipment in 5180. E-mail dgplab(a)dgp.toronto.edu for a time on Friday this week or Tues/Fri next week when you would be available for training. In preparation, there are some videos for the new soldering station. https://www.youtube.com/watch?v=6GEn8nE1RZs https://www.youtube.com/watch?v=6rmErwU5E-k&t=1s https://www.youtube.com/watch?v=Fp37DPZVdRI There are also some useful documentation and videos on the 3d printers, which can be found here: https://www.dgp.toronto.edu/dgpwiki/3dPrinting Room access will be enabled for those who attend the training, subject to faculty approval. If you do not have access to the dgp wiki (https://www.dgp.toronto.edu/dgpwiki/5180MonitorAndCleanup) please let me know. As part of the training, I'll also include a tutorial of how to use the video/audio conference, recording and presentation in 5187 (Seminar room). This isn't required for the hardware training, but useful for running meetings or talks in the Seminar room. If the room is busy during your training session we'll arrange another time for that part. Thanks, -John

1 0

Training for the hardware room access
by John Hancock 02 May '22

02 May '22

Hi Everyone, We're restarting training for the hardware space. If you are interested in getting an update or having your door access re-instated, I'm going to run some sessions this week and over the next few weeks to train on the equipment in 5180. E-mail dgplab(a)dgp.toronto.edu for a time on Tuesday, Wednesday or Friday this week when you would be available for training. In preparation, there are some videos for the new soldering station. https://www.youtube.com/watch?v=6GEn8nE1RZs https://www.youtube.com/watch?v=6rmErwU5E-k&t=1s https://www.youtube.com/watch?v=Fp37DPZVdRI There are also some useful documentation and videos on the 3d printers, which can be found here: https://www.dgp.toronto.edu/dgpwiki/3dPrinting Room access will be enabled for those who attend the training, subject to faculty approval. If you do not have access to the dgp wiki (https://www.dgp.toronto.edu/dgpwiki/5180MonitorAndCleanup) please let me know. As part of the training, I'll also include a tutorial of how to use the video/audio conference, recording and presentation in 5187 (Seminar room). This isn't required for the hardware training, but useful for running meetings or talks in the Seminar room. If the room is busy during your training session we'll arrange another time for that part. Thanks, -John

1 0

2025

2024

2023

2022

2021

2020

2019

2018

2017

Hardware May 2022