Hardware June 2018

hardware@dgp.toronto.edu

1 participants
3 discussions

5180 and Seminar Room training June 27th, 3:30pm
by John Hancock 27 Jun '18

27 Jun '18

Hi Everyone, I will be doing an updated hardware training session on Wednesday, June 27th at 3:30 pm. This is an update, so not required for those who already have access but recommended as we will be reviewing useful information about the new 3d printer, how to print to it remotely and how to dispose of cleaning station fluid correctly, as well as some laser cutter tips. I will also follow it with an introduction to conferencing and recording systems we now have it place in the lab, mostly based in the seminar room. I’ll talk about how to invite remote participants by phone or video, record lectures and run multiple simultaneous input sources to different screens in the room. For people without room access, it will be enabled for those who attend the training, subject to faculty approval. If you do not have access to the dgp wiki (https://www.dgp.toronto.edu/dgpwiki/5180MonitorAndCleanup) please let me know. Thanks, -John

1 0

5180 and Seminar Room training
by John Hancock 18 Jun '18

18 Jun '18

Hi Everyone, I will be doing an updated hardware training session on Thursday, June 21st at 3:30 pm. This is an update, so not required for those who already have access but recommended as we will be reviewing useful information about the new 3d printer, how to print to it remotely and how to dispose of cleaning station fluid correctly, as well as some laser cutter tips. I will also follow it with an introduction to conferencing and recording systems we now have it place in the lab, mostly based in the seminar room. I’ll talk about how to invite remote participants by phone or video, record lectures and run multiple simultaneous input sources to different screens in the room. For people without room access, it will be enabled for those who attend the training, subject to faculty approval. If you do not have access to the dgp wiki (https://www.dgp.toronto.edu/dgpwiki/5180MonitorAndCleanup) please let me know. Thanks, -John

1 0

New Cleaning Instructions for Stratasys F170
by John Hancock 13 Jun '18

13 Jun '18

Hi Everyone, _Print Head Cleaning_ We had our support tech in this week from Cimetrix to check out an issue with print head errors on the F170. The errors may be related to the age of the print head, but he noticed a build up of material around the model print head. To help prolong the lifetime of the print heads, it is important to clean the build chamber regularly when printing with the F170 (and to check the Dremel print head for buildup). Check it after every job you run and remove any stray filament stuck to the sides or on the bottom. For the Dremel, make sure the nozzle is clear as well. _ECOWorks Cleaning_ We have run through our supply of waterworks cleaning solution so it has been replaced with ecoworks cleaning solution. Instead of emptying the jar there are 6 tabs to be added to the water. The EcoWorks packages are found beside the F170 on the taller table. -John

1 0

2025

2024

2023

2022

2021

2020

2019

2018

2017

Hardware June 2018