Hardware February 2018

hardware@dgp.toronto.edu

3 participants
3 discussions

Re: [Hardware] 5180 Training session Thursday Feb. 22nd 3:30 pm
by Joseph Raghubar 23 Feb '18

23 Feb '18

Daniyal and Caleb, your access for dgp hardware lab (BA 5180) is now updated -----Original Message----- From: Joseph Raghubar [mailto:josephr@cs.toronto.edu] On Behalf Of John Hancock Sent: Friday, February 16, 2018 3:19 PM To: hardware(a)dgp.toronto.edu; Daniyal Liaqat <daniyal.liaqat(a)outlook.com>; Caleb Phillips <caleb.phillips(a)uoit.net>; Mingzhe Li <franklin.li(a)mail.utoronto.ca> Subject: [Hardware] 5180 Training session Thursday Feb. 22nd 3:30 pm Hi Everyone, I will be doing an updated hardware training session on Thursday, Feb 22nd at 3:30 pm. This is an update, so not required for those who already have access but recommended as we will be reviewing useful information about the new 3d printer, how to print to it remotely and how to dispose of cleaning station fluid correctly, as well as some laser cutter tips. For people without room access, it will be enabled for those who attend the training, subject to faculty approval. If you do not have access to the dgp wiki (https://www.dgp.toronto.edu/dgpwiki/5180MonitorAndCleanup) please let me know. Thanks, -John _______________________________________________ Hardware mailing list Hardware(a)dgp.toronto.edu https://www.dgp.toronto.edu/cgi-bin/mailman/listinfo/hardware

1 0

Hardware Lab Mess Clean Up
by Peter Hamilton 20 Feb '18

20 Feb '18

Hi everyone, The mess in the hardware space is getting out of hand again. If some of this mess is yours, please tidy it up by the end of the week. If you know who is responsible for some of this mess, please ask them to handle it. If things don't improve, there will be dire consequences for everyone. -Peter Hamilton (This weeks 5180 monitor)

1 0

5180 Training session Thursday Feb. 22nd 3:30 pm
by John Hancock 16 Feb '18

16 Feb '18

Hi Everyone, I will be doing an updated hardware training session on Thursday, Feb 22nd at 3:30 pm. This is an update, so not required for those who already have access but recommended as we will be reviewing useful information about the new 3d printer, how to print to it remotely and how to dispose of cleaning station fluid correctly, as well as some laser cutter tips. For people without room access, it will be enabled for those who attend the training, subject to faculty approval. If you do not have access to the dgp wiki (https://www.dgp.toronto.edu/dgpwiki/5180MonitorAndCleanup) please let me know. Thanks, -John

1 0

2025

2024

2023

2022

2021

2020

2019

2018

2017

Hardware February 2018